Nalpak TP-1124 11″ Tuffpak Series Hard Tripod Case (Black)

• For Tripods 24-29″ with 150mm Ball Head
• Molded Polyethylene Case
• 2″ of Foam in Lid and Base
• Molded Carry Handle
• ID Card Holder on Top of Case
• Adjustable Strap Secures Lid

Store, protect, and transport select tripods between 24 to 29″ long, with an up to 150mm ball head, in the black TP-1124 Tuffpak Hard Tripod Case from Nalpak . For strength and durability, this 11″ wide, octagonal case is made from roto-molded, cross-linked polyethylene. The inner top and bottom of the case is fitted with 2″ of impact-cushioning foam. A plastic lid covering the bottom inner foam serves to preserve the integrity of the foam. Carry the tripod case with the robust molded handle. Photographers will appreciate the ID card holder located on top of the case, and the adjustable strap that secures the lid.

Snugly holds a tripod with a length of 24 to 29″ with the lid fully extended. The 11″ case diameter is appropriate for tripods with up to a 150mm ball. For strength and durability, each case is made from rotationally-molded, cross-linked polyethylene. Tuffpak material is resistant to jet fuel, solvents, moisture, dents, abrasions, shock, cold to -40F, and heat to 140F. To protect gear from impact, the case comes with 2″ of foam in the lid and the base. The foam in the base (which is protected from the feet of the tripod by a plastic disk) is held in place by detents molded into the base of each case. The foam in the lid is glued-in. Recessed, molded-in carry handle In the Box Nalpak TP-1124 11″ Tuffpak Series Hard Tripod Case (Black)

• Limited Lifetime Warranty

All product and company names are trademarks or registered trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them.